Henkel Multicore/Loctite Solder Flux MF200

Henkel Multicore Solder Flux MF200 It is important to remove excess flux from the circuit boards using the standard air knife supplied on the wave soldering machine. Sufficient air pressure must be used and the nozzle should be about 25 mm below board and angled back at a few degrees from the perpendicular to the plane of the board. This will ensure effective removal of excess flux without transferring droplets to the top of the following board. TDS (PDF)MSDS (PDF) - 1 Gallon Bottle - contact us MSDS (PDF) - 5 Gallon Box - contact us *This material is considered Haz-Mat and must ship ground* **Other fees may apply during shipping**